Ways to Reset the Service Light on a Ford Explorer 1Open the fuse panel cover on your Ford Explorer under the steering column. Turn the knob on the cover and pull down on the fuse panel cover.2Plug the connector on the diagnostic tool into the port on the fuse panel. There's only one port big adequate to accept the diagnostic tool's connector.
3Turn the ignition important towards the "II" position car diagnosis tool.4Wait for the service light to go out. At this point, the service light has been reset. Ways to Reset the SRS Light on a Mercedes 1Locate the fuse panel cover and remove it. This is located on the decrease left side of the control panel on the driver's side of your vehicle. Uncover the port that fits the OBD cable and plug the scan tool's cable into this port.2Put the key into the ignition and turn it for the "Run" position.
This really is the position just just before the engine starts. Look at your OBD scan tool and write down the codes it displays.3Check your owner's manual for what the codes imply.4Unplug the scan tool and place the fuse panel cover back in location. Take your car for your nearby Mercedes dealer to possess repairs created GM MDI, if necessary.5Repeat step 1 any time you return household. Place the essential in to the ignition and turn it to the "Run" position. Wait until the SRS light turns off. Get rid of the cable and place the fuse panel cover back in place.
No comments:
Post a Comment